top of page

Sabre 38 Salon Express Specifications

 

 

Length (w/o anchor pulpit or swim platform)              38’/11.59m

Beam                                                                                   13’4”/4.06m

Deadrise at transom                                                         17 degrees

Displacement (est. full load)                                            21,500lbs/9773kg

Standard engines                                                               Volvo Penta D4 IPS 400 with pods

Fuel capacity                                                                       300 usg/1125l  

Water capacity                                                                    100 usg/380l  

Headroom                                                                            6’6”/1.98m  

Sleeping accommodations                                                4@6/6”/1.98M  

 

 

>Download the Sabre 38 Salon Express Standard Equipment List

 

HULL

 

Modern planning V-Hull

VIP Resin infused laminate

SAN Corecell foam coring

Knitted bi-axial structural reinforcements

Foam/Plywood stringer system

Swim platform with under mounted ladder

PVC rub rail with stainless steel cap

LP painted boot strip

Gold cove stripe

 

DECK

 

VIP resin infused laminate

Molded in anti-skid surfaces

Anodized Aluminum framed windows

Large diameter stainless steel perimeter rails

Herreshoff  bow and spring cleats

Horn style aft mooring cleats

Low profile opening hatches with shades and screens

Low profile pilot hatches in hard top

Stainless steel anchor roller

Aft cockpit seat slides to expand cockpit

 

MECHANICAL

 

Twin Volvo Penta D4 300HP engines linked to VP IPS drives

3.7l (4) cylinder fresh water-cooled Includes Volvo electronic controls

Volvo Active Corrosion Protection system, GPS receiver and NMEA

backbone

12V alternators each engine.

Volvo raw water intake strainers

Engine room blower.

Engine room vent ducts.

White gelcoated engine room

Mylar Foil face foam noise barrier.

6kW Koehler Generator

 

ELECTRICAL

 

(2) 30 Amp 50 foot shore power cords

Galvanic isolator

Illuminated circuit breaker panel opposite galley

120v outlets throughout interior and in engine room

Galley and head receptacles are GFI protected

(2) Dedicated engine start batteries

(2) Group 4D house batteries

LED overhead and reading lights

60 Amp 3-bank battery charger

Tinned wire used throughout

 

PLUMBING

 

Single Polyethylene 100usg. water tank

11usg stainless steel hot water tank

Stainless sink in galley

Vessel sink in head

Fresh water flush MSD w/holding tank and macerator

Shower stall in head with tempered glass door

Solid surface material and galley and head countertops

Marelon sea valves on all below waterline fittings

(3) bilge pumps with high water alarms

 

SALON/HELM DECK

 

Stidd 500N series helm seat

Stazo wooden steering wheel

Ultraleather wrap on helm/ navigation pod

Mates L-settee to port converts to face salon table

94” x 50” Raised U-shaped settee to port with storage under

Storage cabinet to starboard with LED television on mechanical lift

Stainless steel aft bulkhead with bi-fold door

Electrically operated drop down window to port

Curved acrylic windows in aft corners

Elegant inlaid main salon table

 

GALLEY

 

Solid surface countertop

Stainless steel sink and faucet

Microwave oven

Ceramic two burner cook top

Two drawer stainless steel fridge-freezer AC/DC

Storage in galley lockers and below helm deck

Galley open to main salon

Opening stainless steel portlight over galley

 

CABINS

 

Master stateroom forward with Queen size island berth

Storage below berth and in shelf lockers

Hanging locker with cedar lining

Large passageway door to galley

Television on bulkhead raises and lowers to open cabin to galley

Two overhead hatches in master

Lower lounge below helm deck open to galley

Lower lounge has slide out berth filler

Reverse cycle heat and air conditioning

Private access to head compartment from master cabin

bottom of page